Mô tả

Bộ chuyển đổi Modbus TCP/IP sang HART ICP DAS HRT-711 CR

Features

  • Support HART Short/Long frame
  • Support HART Burst mode
  • Allow two HART Masters
  • Working in point-to-point or multi-drop HART mode
  • Connecting up to 15 HART modules
  • Support Modbus TCP/UDP server
  • Support Modbus Slave mode
  • Support firmware update via Com Port
  • Support on-line replacement of HART devices
  • Support acquire Long Frame Address automatically
  • Provide LED indicators
  • Built-in Watchdog
  • Mountable on DIN Rail

Introduction

HRT-711 được thiết kế đặc biệt cho thiết bị Master của giao thức HART. Nó cho phép Modbus master truy cập các thiết bị HART. Các thiết bị HART này có thể là một bộ phát, bộ truyền động, v.v. Ngoài ra, chúng tôi còn cung cấp phần mềm tiện ích để người dùng cấu hình HRT-711. Bằng cách sử dụng mô-đun này, người dùng có thể tích hợp các thiết bị HART của họ vào mạng Modbus một cách dễ dàng.

Applications

  • Industrial Automation
  • Factory Automation
  • Process Automation
  • Etc…

Specifications

COM Ports
Ports RS-232(3 wires)
Ethernet
Ports 10/100Base-TX Ethernet Controller (Auto-negotiating, Auto_MDIX)
HART
Ports 1
Device 2-wired or 4-wired HART devices
Topology Point to Point or Multi-Drop
Data Only Digital Data
Frame Type Short and Long Frame
Burst Mode Supported
Max. HART Device 15
Loop Resistor 250 Ω resistor by Jumper
Isolation UL1577 Spec.
Protocol 2-pin screwed terminal block
Power
Reverse Polarity Protection Power reverse polarity protection, Over-voltage brown-out protection
Input Range Unregulated +10 ~ +30 VDC
Consumption 1 W
Mechanical
Dimensions (mm) 72 x 35 x 121 (W x L x H) Detail
Installation DIN-Rail or Wall Mounting
Environment
Operating Temperature -25 ~ +75 °C
Storage Temperature -30 ~ +80 °C
Humidity 10% ~ 90% RH, Non-condensing

Download

Datasheet

Documents

Ordering Information

HRT-711     CR  Modbus TCP/UDP to HART Gateway (RoHS)
Đăng nhập
Đăng ký
Hotline: 0904251826
x