
- Giao thức và hệ thống phân cấp: DP-V0 & DP-V1 Slave
- Hỗ trợ tốc độ truyền PROFIBUS (Kbps) : 9.6, 19.2, 45.45, 93.75, 187.5, 500, 1500, 3000, 6000, 12000
- Cài tốc độ truyền: tự động phát hiện
- Chiều dài dữ liệu vào tối đa: 240 Byte
- Chiều dài dữ liệu ra tối đa: 240 Byte
- Cài đặt địa chỉ: 0~126 bộ bởi DIP switch hoặc EEPROM
- Hỗ trợ chế độ Modbus: Master/Slave
- Hỗ trợ định dạng Modbus: RTU/ASCII/TCP
- Ethernet : 10/100 Base-TX
- COM 1 hỗn hợp: RS-232/422/485 với “tự điều chỉnh” bên trong
- Hỗ trợ tốc độ truyền COM 1 (Kbps) : 2.4, 4.8, 9.6, 19.2, 38.4, 57.6, 115.2
- Hỗ trợ định dạng dữ liệu COM 1: 7/8 data bits, No/Odd/Even parity, 1/2 stop bit
- Chỉ báo: PWR, ERR, và RUN LEDs
- Bảo vệ mạng cách ly: 2500 Vrms iCoupler tốc độ cao
- Bảo vệ DC cách ly: 3000VDC ở PROFIBUS
Thông số kỹ thuật
CPU Module | |
---|---|
CPU | 80186, 80 MHz or compatible |
EEPROM | 16 KB |
Flash | 512 KB |
SRAM | 512 KB |
Watchdog Timer | Watchdog IC CPU built-in |
LED Indicators | |
---|---|
Status | PWR LED, RUN LED, ERR LED |
COM Ports | |
---|---|
Ports | RS-232 (For updating firmware and configuration) 5-pin screwed terminal block (TxD, RxD, RTS, CTS, GND ) |
Baud Rate | 2400, 4800, 9600, 19200, 38400, 57600, 115200 |
Parity | None, Even, Odd |
Data Bit | 7, 8 |
Stop Bit | 1, 2 |
Ethernet | |
---|---|
Ports | 10/100Base-TX Ethernet Controller (Auto-negotiating, Auto_MDIX) |
PROFIBUS | |
---|---|
Controller | Profichip VPC3+C |
Transceiver | ADI ADM2486 |
Baud Rate | 9.6 k, 19.2 k, 45.45 k, 93.75 k, 187.5 k, 500 k, 1.5 M, 3 M, 6 M, 12 M |
Isolation | 3000 VDC for DC-to-DC, 2500 Vrms for bus-to-logic |
Protocol | DP-V0 & DP-V1 |
Power | |
---|---|
Consumption | 2.5 W |
Mechanical | |
---|---|
Dimensions (mm) | 72 x 33 x 119 (W x L x H) |
Installation | DIN-Rail |
Environmental | |
---|---|
Operating Temperature | -25 ~ +75℃ |
Storage Temperature | -30 ~ +85 ℃ |
Humidity | 5 ~ 95% RH, Non-condensing |
Ứng dụng
- Công nghiệp tự động hóa
- Tự động háo nhà máy
- Tự động hóa quy trình
Quản trị Web-based
Cung cấp cài đặt giá trị an toàn
Cung cấp cấu hình mạng
Hiển thị tham số module và thông tin thiết bị
Hiển thị nhật ký truyền thông giữa GW-7553 và thiết bị Modbus
Module hỗ trợ
Chỉ những lệnh modbus dưới dây là được hỗ trợ bởi gateway này
Code | Name | Description |
---|---|---|
01 | Read Coil Status | Read the ON/OFF status of discrete outputs in the slave |
02 | Read Input Status | Read the ON/OFF status of discrete inputs in the slave |
03 | Read Holding Registers | Read the binary contents of holding registers in the slave |
04 | Read Input Registers | Read the binary contents of input registers in the slave |
05 | Force Single Coil | Write a single output to either ON or OFF in the slave |
06 | Preset Single Register | Write an integer value into a single register in the slave |
15 | Force Multi. Coils | Write each coil in the sequence of coils to either ON or OFF in the slave |
16 | Preset Multi. Registers | Write a block of contiguous registers in the slave |
Thông tin đặt hàng
GW-7553-B CR | PROFIBUS to Modbus TCP Gateway (Plastic Case) (RoHS) |